Loading

Prev Menu Next
NN3 & NN3 MKII Complete Manual

7. Removing and Replacing Detent Springs on NN3 only

The click stop tension can be tightened to the desired strength giving you good precision. Use the hex key included with your Nodal Ninja to loosen the hex screw on the underside of the lower rotator. Replace spring and retighten. This hex screw tightens a little internal spring, causing more tension to the pin that drops into the detent plate. Do this in concert with properly adjusting the tension on the rotator base as well. Both these adjustments together allow for greater customization.
Screw the detent tension hex nut just below the rim to leave enough spring movement.

Removing and Replacing Detent Springs on NN3
Removing and Replacing Detent Springs on NN3
Removing and Replacing Detent Springs on NN3
Removing and Replacing Detent Springs on NN3

© 2018 Nodal Ninja ®