Loading

Prev Menu Next
NN4 Complete Manual

6. Removing and Replacing Detents

Disassemble the lower rotator assembly by completely unscrewing the friction set knob on top (with markings).

Lower rotator assembly
NN5 - removing and replacing detents
Using the hex key
Using the enclosed hex key loosen the inner hex screw enough to release detent ring. Some units may have the hex key tool located inside the tension knob, as shown above. Place the detent ring with desired side face up. Tighten hex screw and reassemble.
At the time of this writing we have the following rings available:
Reversible detent rings

© 2018 Nodal Ninja ®