Loading

Prev Menu Next
NN5 & NN5L Complete Manual

6. Removing and Replacing Detents


Changing the Detent Ring on the NN5 or 5L (standard rotator)



Disassemble the lower rotator assembly by completely unscrewing the friction set knob on top (with markings).

NN5 - removing and replacing detents
NN5 - removing and replacing detents
NN5 - removing and replacing detents
NN5 - removing and replacing detents
Using the enclosed hex key loosen the inner hex screw enough to release detent ring. Some units may have the hex key tool located inside the tension knob, as shown above. Place the detent ring with desired side face up. Tighten hex screw and reassemble.

At the time of this writing we have the following rings available:
Reversible detent rings

© 2018 Nodal Ninja ®