Loading

Prev Menu Next
Nodal Ninja Quick Reference Guides

M1 Ultimate Series

M1-S Ultimate Series


1.

Install 2 anti-twisting screws on QRC-55.

2.

Mount the QRC-55 to lower rotator using an M6 screw.


Ultimate M1

Install anti-twisting screws here

Ultimate M1

3.

Attach MFRDovetail 35 to the end of MFR-160, by using 2 M5 screw with brass fitting.


M1S

4.

Install QRC-35 to MFVR-160 by using 2 M5 screw with brass fitting.


5.

Install a machined M3 cup screw at the central socket of QRC-35 to act as a stop screw.


Notice the orientation of MFVR-160 and QRC-35.

M1S

6.

Mount the upper rotator to MFVR-160 using 4 M4 flat head screws. The 0 degree mark should be at horiontal position.

7.

Press the plastic fitting to upper rotator tightening knob. Tighten the knob to the upper rotator and then install the knob retention screw.


M1S

Notice the orientation of MFVR-160


8.

Install 2 anti-twisting screws on the QRC-55.

9.

Mount the QRC-55 to upper rotator using a 3/8" screw.


Ultimate M1

10.

Install a 3/8" to 1/4" adapter on the QRC-40A.

11.

Install an anti-twisting screw on the QRC-40A.

12.

Install a 1/4" screw on MFR-160. Mount the QRC-40A to MFR-160 using the 1/4" screw while sliding the 1/4" screw to the far end.


Install an anti-twisting screw here

Ultimate M1
Click to enlargeUltimate M1

Slide the 1/4" screw and QRC-40A far most


13.

Slide the QRC-35 to far left or right so that it is flush with plate below. Tighten the knob on QRC-35.

14.

Slide MFR-160 along QRC-55 to set correct NPP for upper and lower rotators.


M1S

Only buy from authorized resellers. If buying new from other than an authorized reseller, no warranties or product support are included.

© 2017 Nodal Ninja ®